Follow

MX2 Firmware and Settings

You must use GBUploadFirmware to install GBTimelapse compatible firmware on your MX2. GBUploadFirmware can also easily restore the original standard firmware.

After installation, make these changes to the MX2 settings..

  • Settings>USB Trigger ON
  • Settings>Motor S1.Mod>Interleave
  • Settings>I/O 2>Disable

 

Problem: MX2 dolly moves twice

If your MX2 dolly moves twice for each exposure, the settings are incorrect.

  • In the GBTimelapse Shutter tab, check the box for EXT bulb control.
  • In the MX2 settings set Settings>I/O 2>Disable

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Article is closed for comments.
Powered by Zendesk